I just enabled the "default" bw limit on my AP (on the 802.11 side) and my
client ping times jumped to triple digits. Prior to that they were at <15
-bob
> >
> > Supposedly the wireless side regulates the client upload speed, and the
> > Ethernet bandwidth setting regulates the client download speed, but in
> > practice, I've only been able to effect a symmetrical bw limiting with
> these
> > settings. Anyone else had better luck?
> >
> > And on another note about the Polling Base Station, I found to my great
> joy
> > that if I turned off polling on our backhaul, the ping times dropped
down
> > into the low single digits, rather than the high double sometimes triple
> > digits. Should have been obvious, but it wasn't...
> >
> > Norm
> >
> > ----- Original Message -----
> > From: "Bob Hrbek" <bhrbek@jagwireless.com>
> > To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
> > Sent: Tuesday, February 11, 2003 9:38 AM
> > Subject: [Karlnet] turbocell advanced settings
> >
> >
> > > when configuring a TC AP, under the advanced settings there is an
> advanced
> > > tab where you set the network ID and 802.11 speed. There is also a
> > > bandwidth setting. Does this setting modify the sattelite upload or
> > > download or both?
> > >
> > > thanks,
> > > bob
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
>
|