Hector,
I don't think your question is appropriate for this mailing list but to answer
your question (assuming you're doing this with Configurator)
For this example, I need to assume 192.168.101/24 is ethernet (interface 1) and
192.168.102/24 is on wireless (interface 2)
- Under "General Setup", check "Enable IP Routing"
- Click the "Add/Direct" button and enter 192.168.101.1 Choose Interface 1
- Click the "Add/Direct" button again and enter 192.168.102 .1 Choose
Interface 2
Computers on the ethernet segment should have a default gateway of 192.168.101.1
Computers using the wireless segment should have a default gateway of
192.168.102.1
*********** REPLY SEPARATOR ***********
On 2003-Aug-03 at 1:52 AM Hector Menjivar wrote:
>Hi:
>
> Im trying to connect to networks:
>network a: 192.168.101.x mask 255.255.255.0 and
>network b: 192.168.102.x mask 255.255.255.0
>
>would you tell me how can I route the traffic between the two
>networks..im really a newbie..please help me ASAP.
>
> Thanks a lot
>
> Hector
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
|