I'm sure it is, since we use karlnet, we have to wait for them to do it
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Eden Akhavi
> Sent: Tuesday, August 05, 2003 8:26 PM
> To: 'Karlnet Mailing List'
> Subject: RE: [Karlnet] low cost cpe's - wish list -0
>
> Dan,
>
> This is easily configured in software (ie Karlnet can do this). The
LEDs
> are just hanging off the IP2022, what we have done on ours is
configure
> one LED as a 'Wireless Link Up', do note this is not running Karlnet's
> s/w though. It was a five minute job.
>
> Regards
>
>
>
>
> Eden
>
> > -----Original Message-----
> > From: karlnet-bounces@WISPNotes.com
> > [mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Dan Metcalf
> > Sent: 06 August 2003 01:46
> > To: 'Karlnet Mailing List'
> > Subject: RE: [Karlnet] low cost cpe's - wish list -0
> >
> >
> > On the current ubicom systems, you can't tell if you have a
> > link unless
> > you log into the unit, the WLAN light always seems to flash
> > regardless?
> >
> > --
> > [This E-mail scanned for viruses by Declude Virus]
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]
--
[This E-mail scanned for viruses by Declude Virus]
|