Hector
The setup is not that hard. You need to add a IP address to each interface
for example:
192.168.101.1/255.255.255.0 to Ethernet interface 1
192.168.192.1/255.255.255.0 to Wireless interface 2
Gateway (example) 192.168.101.254
This setup will route all traffic from the wireless to the Ethernet our out
the gateway.
Also make sure you do not have bridging turned on.
Sincerely, Tony Morella
Demarc Technology Group, A Wireless Solution Provider
Office: 908-996-7995 Fax: 908-847-0202
http://www.demarctech.com
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Hector Menjivar
> Sent: Thursday, August 07, 2003 9:36 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Routing question again...
> Importance: High
>
>
> Hi:
>
> Recently I have post a question about routing whit
> AP100, and still can't do it.
> I still need to connect the two networks (192.168.101.x and
> 192.168.102.X) using routing on AP1000, if anybody has and
> idea of what can I do to do that please help me.
>
> Hector
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/ka> rlnet
>
>
|