Karlnet
[Top] [All Lists]

RE: [Karlnet] KN50 Configuration... are we doing it wrong?

To: "'Brett Hays'" <bretth@htonline.net>,"'Karlnet Mailing List'" <karlnet@wispnotes.com>
Subject: RE: [Karlnet] KN50 Configuration... are we doing it wrong?
From: "Jayson A. Baker" <jbaker@peakinet.net>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Tue, 9 Mar 2004 19:24:02 -0700
List-post: <mailto:karlnet@WISPNotes.com>
Yes... Reg is the man.
I'll be talking to him in the AM!  :-)

Regards,
Jayson A. Baker
Peak Internet Solutions

-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of Brett Hays
Sent: Tuesday, March 09, 2004 7:08 PM
To: Karlnet Mailing List
Subject: Re: [Karlnet] KN50 Configuration... are we doing it wrong?

Jayson,

   I am sure you just need to work through some settings issues.  I was as
reluctant as anyone where the KN50's are concerned, but once I learned a few
of the peculiarities of the units and got through some firmware issues with
certain radio cards, I have found them to be every bit as solid as the
RG1100's and KN100's we were using previously at much higher cost.

   If you are having issues with them, call and talk to Ed or Reg at
Karlnet, they are a tremendous help I have found.

Brett Hays
Hometown Online
www.htonline.net

----- Original Message ----- 
From: "Jayson A. Baker" <jbaker@peakinet.net>
To: "'Karlnet Mailing List'" <karlnet@wispnotes.com>
Sent: Tuesday, March 09, 2004 6:48 PM
Subject: RE: [Karlnet] KN50 Configuration... are we doing it wrong?


> Are these things JUNK, or what???
>
> We set to auto channel scan, then our AP sees the KN-50 for a few seconds,
> then it drops out, and over and over again.
>
> So we set it to channel 1 only, our AP shows it in "Compatible" mode, with
> good SNR, etc. but the KN-50 shows no signal at all.  Passes no traffic,
> etc.
>
> We must be doing something wrong... please advise.
>
> Regards,
> Jayson A. Baker
> Peak Internet Solutions
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Jayson A. Baker
> Sent: Tuesday, March 09, 2004 4:32 PM
> To: 'Karlnet Mailing List'
> Subject: [Karlnet] KN50 Configuration... are we doing it wrong?
>
> Hi,
>
>
>
> Seems as though no matter what we input into the configuration pages for
> these KN-50 board, when we save and restart the unit, it sets everything
> back to defaults.
>
>
>
> Are we doing something wrong here, or does Karlnet need to do some serious
> software upgrades to these boards?
>
>
>
> Regards,
>
> Jayson A. Baker
>
> Peak Internet Solutions
>
> Phone: (719) 686-1490
>
> Facsimile: (719) 686-1864
>
> E-Mail: jbaker@peakinet.net
>
> Web: http://www.peakinet.net/
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet



_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

<Prev in Thread] Current Thread [Next in Thread>