| To: | karlnet@WISPNotes.com |
|---|---|
| Subject: | [Karlnet] KN-205 pass through of PoE voltages from Ethernet1 toEthernet2 |
| From: | Joe Correia <Joe@FallRiverOnline.com> |
| Reply-to: | Karlnet Mailing List <karlnet@WISPNotes.com> |
| Date: | Sun, 18 Jul 2004 12:35:22 -0400 |
| List-post: | <mailto:karlnet@WISPNotes.com> |
|
Not sure if this applies to the 205 boards but it's a start. 1) Enable PoE injector on Second Ethernet Port (eth2) Both Pins 1 has 2 jumpers – Not Jumpered (default) Jumper both sets of Jumpers (1 & 2) if the second Ethernet Port is to be used as a Power over Ethernet injector, supplying power to another PoE enabled attached device --Joe karlnet-request@WISPNotes.com wrote:
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Karlnet] KN-205 pass through of PoE voltages from Ethernet1 toEthernet2, Norm Young |
|---|---|
| Next by Date: | [Karlnet] AP LOCK up/ won't pass ip traffic but link test works, Joe Correia |
| Previous by Thread: | [Karlnet] RE: heat and PoE, David Dietrich |
| Next by Thread: | Re: [Karlnet] KN-205 pass through of PoE voltages from Ethernet1toEthernet2, Norm Young |
| Indexes: | [Date] [Thread] [Top] [All Lists] |