To: | karlnet@WISPNotes.com |
---|---|
Subject: | [Karlnet] KN-205 pass through of PoE voltages fromEthernet1toEthernet2 |
From: | Joe Correia <Joe@FallRiverOnline.com> |
Reply-to: | Karlnet Mailing List <karlnet@WISPNotes.com> |
Date: | Sun, 18 Jul 2004 21:20:53 -0400 |
List-post: | <mailto:karlnet@WISPNotes.com> |
It should be "J1" However
http://www.karlnet.com/Documents/KN-105-KN-205%20Printed%20Circuit%20Board%20(PCB)%20User%27s%20Guide.pdf doesn't say anything about J1. I could be wrong but I believe it's the 4 pins right next to J3. --Joe
|
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Karlnet] KN-205 pass through of PoE voltages from Ethernet1toEthernet2, Norm Young |
---|---|
Next by Date: | Re: [Karlnet] KN-205 pass through of PoE voltagesfromEthernet1toEthernet2, Norm Young |
Previous by Thread: | [Karlnet] Config Program?, Joe Correia |
Next by Thread: | Re: [Karlnet] KN-205 pass through of PoE voltagesfromEthernet1toEthernet2, Norm Young |
Indexes: | [Date] [Thread] [Top] [All Lists] |