You might check the firmware on the cards... one version doesn't report any
signal, the other reports signal but no noise.
----- Original Message -----
From: <joe@rockymountains.net>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Tuesday, February 15, 2005 2:33 PM
Subject: [Karlnet] SMC radio card question
> I have about 150 KN-XXX boards deployed with SMC2532W-B radios on them.
> Recently the label has changed on these radios and I am only getting 1
(link
> test form client to AP, turbocell) on the local level in my test setup.
The
> remote level looks normal. When the older cards do this it means they're
> toast.
>
> What I'm wondering is if this is a problem or not. I will find out
> eventually because I have to deploy these.
>
> If any one out there has any advice please chip in.
>
> Thanks,
> Joseph Conrad
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|