I soldered up the DB-25 on the LPT1 port to support the paddles. This
is the same interface I have been using for years, but finally decided I
needed to put the keyer paddles on it too. Soldered it up according to
the book, and when I plugged it back in, it locked up the keyer sending
alterdate dit & dahs. Checked it out electrically, and it was OK. Anyone
else have this problem, and was the answer to use higher valued
resistors. I used 10K as the manual specified. Thanks in advance
Paul, K2DB
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://www.contesting.com/datom/
Questions: owner-na-user@contesting.com
|