I just upgraded from 10.21 to 10.32 and have a couple of minor problems. I
can open an existing log with no problem, but when I try to run the new built-
in config function from the DOS prompt by entering "NA CONFIG", I get a
message "DX Multiplier File cannot be found". Note that the file paths in the
old config were ok. Any suggestions?
Also, I have a Kenwood TS-850 which I have been using successfully with NA. I
now notice that there are 2 Kenwood items in the Radio List. Which is the
right one for my radio (KENWOOD1 or KENWOOD2)?
Thanks,
Warren (KG2BI)
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://www.contesting.com/datom/
Questions: owner-na-user@contesting.com
|