Dave,
I left out something in my last email.
When I said press space after changing the QTH field I should have said
press it 2 times.
1 time only puts the cursor back to the call field.
When pressed again it does the check .
Ken
----- Original Message -----
From: "k8cc" <k8cc@mediaone.net>
To: "Kenneth Wilson" <kg4big@mindspring.com>; <na-user@contesting.com>
Sent: Thursday, October 05, 2000 10:32 PM
Subject: Re: [na-user] Dupe checking
>
> At 04:56 PM 10/5/00 -0400, Kenneth Wilson wrote:
> >Setting up Ver. 10.49 for the CA qp. Under options I have checked QTH
> >must match for dupe . I always do that for state QP's. Dupe checking
> >works fine when the QTH has 4 letters in it but not when its 2 or 3.
>
> I don't see the problem here. If I start a CQP log, and log K6LA/001/LAX
> on 160M, then log K6LA/002/LAX on 160M and it correctly shows up as a
dupe.
>
> Perhaps you are referring to when you enter a call and press the spacebar
> or F9? With "QTH Must Match For Dupe", under these conditions the
> dupechecking will not flag a dupe because you've not entered a QTH (in
CQP,
> a county) yet. Its only when you log a QSO where the QTH is included that
> a dupe can be determined with "QTH Must Match For Dupe" turned on.
>
>
> Dave Pruett, K8CC
> DATOM Engineering
> datom@contesting.com
> http://datom.contesting.com
>
>
> --
> Submissions: na-user@contesting.com
> Administrative requests: na-user-REQUEST@contesting.com
> WWW: http://datom.contesting.com/
> Questions: owner-na-user@contesting.com
>
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://datom.contesting.com/
Questions: owner-na-user@contesting.com
|