The solution, sadly, is to reload v 1.372. That's what many of us
have done. This beta version is way too much "beta". Sad, because it
shows a lot of promise.
AN worked OK for me, but the SP situation was unacceptable.
Would anyone like to start a pool and take a bet on when the next
non-beta Orion 1 version comes out? Probably not soon, or they would
not have released 2.054b.
73 Martin AA6E
On 2/19/06, Andy Hamon <andyh@cwgsy.net> wrote:
> Guys
>
> Loaded the new v2 firmware onto my Orion yesterday afternoon and
> tried it in the ARRL test.
> The "upload" went fine and after doing the Master Reset and
> reconfiguring my parameters, everything is great EXCEPT one thing.
>
> When I switch in the auto notch, the audio goes from being crystal
> clear to unreadable! At setting 1, the signal is just readable, only
> just. At setting 9, forget it. The radio sounds like a real cheap AM
> BC receiver being overloaded. The distortion is awful.
>
> Same result in SSB as CW.
>
> Under firmware v1, no such problem.
>
> Is it worth reloading the firmware?
> Is it a setting a bit further up the chain that is overdriving
> something when the auto notch?
> Is it a user problem?
>
> Any suggestions??
>
> Thanks & 73
>
> Andy, GU4WTN
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
--
martin.ewing@gmail.com
http://blog.aa6e.net
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|