I too have a treadmill, but not quite as elaborate as yours.
The directions with mine recommended it not be left turned on
when not in use, so I put an outlet strip with an on/off switch
in line to the wall outlet. Now I can turn it on when I want
to use it, and off when I leave. It also gives me a place to
plug in a fan for exercise on warm days :-)
73, Bob N6WG
From: email@example.com [mailto:firstname.lastname@example.org]On
Behalf Of Dohmen, Ron (MPAU)
Sent: Tuesday, August 19, 2003 6:07 AM
Subject: [RFI] Treadmill RFI
I am having trouble with RFI to my wife's treadmill. The treadmill is a
top-of-the-line model, with programmable exercise routines, elevation
control, heart rate monitor, etc.
There is no on/off switch on the treadmill, instead there is a magnetic
kill switch that is tethered to the user. When the kill switch is
pulled out of the socket, the treadmill stops. With the kill switch
removed, the treadmill appears to be powered off, but the internal
electronics is powered whenever the line cord is plugged in.
The problem occurs when I transmit on 20 or 40 meters, using high power.
The treadmill buzzes, and the elevation motor raises the track. It
keeps on raising until the leadscrew coming out of the motor binds, well
beyond the maximum of 15 degrees track elevation. To get the track
elevation mechanism working again, I have to take the treadmill apart,
and manually turn the leadscrew.
I tried installing torids on the line cord and on the control wires
going to the internal pc board. I also tried a line filter on the power
line. I tried moving the treadmill to the other side of my house.
Nothing seems to help.
I don't think unattended operation of the motor is very safe. Is there
a government agency I can contact, to try to get the manufacturer to fix
I wrote to the manufacturer, their reply is attached. Subsequent emails
to them have been ignored.
Ron Dohmen N0AT
> Ron Dohmen
> Mr Dohmen
> The problem is not with the treadmill but the proximity of the
> which through the air (as opposed to coming through the line cord)
> a signal which is activating the elevation circuit. The simple
> would be
> to unplug the treadmill from the wall outlet when not in use, and when
> use do not
> operate the transmitter.
> The other possibility would be to relocate the treadmill. This may or
> not be effective
> depending on the strength of the signal
> Yours in good Health,
> Bill Osbun
> Aerobics Inc
The information contained in, or attached to, this e-mail, may contain
confidential information and is intended solely for the use of the
individual or entity to whom they are addressed and may be subject to legal
privilege. If you have received this e-mail in error you should notify the
sender immediately by reply e-mail, delete the message from your system and
notify your system manager. Please do not copy it for any purpose, or
disclose its contents to any other person. The views or opinions presented
in this e-mail are solely those of the author and do not necessarily
represent those of the company. The recipient should check this e-mail and
any attachments for the presence of viruses. The company accepts no
liability for any damage caused, directly or indirectly, by any virus
transmitted in this email.
RFI mailing list