Is there any magic to the spacing of the beads when you build a
current balun? I bought a kit from Palomar a while back in an attempt
to cure some issues. It's just a series of beads and some shrink
tubing to hold it in place - pretty slick, less than $20. Stuck it on
a length of LMR400 or 9913 and stuck some PL259s on it. No sweat.
Didn't operate as desired, but that wasn't the fault of the balun.
:-)
Question is, if I thought I needed more choking, could I just assemble
another one and add it in to the feedline? Or would it be better to
take the existing unit apart and rebuild it with all the beads
"touching"?
--
Peter Laws | N5UWY | plaws plaws net | Travel by Train!
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|