[Top] [All Lists]


To: Group RFI <rfi@contesting.com>, Repairman AL <alsshop@mchsi.com>, Pike Dan <danpike@charter.net>, NS6C Dennis <ns6c@arrl.net>, N6RT Doug <n6rt@dabware.com>, W6JI Ed <w6ji@socal.rr.com>, N6UY George <n7uy@comcast.net>, Jess W6LEN <W6LEN@aol.com>
Subject: [RFI] FYI - DirecTV TVI
From: rick darwicki <n6pe@yahoo.com>
Date: Sat, 5 Sep 2009 14:36:07 -0700 (PDT)
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
This goes to show you it is usually not OUR problem.

My old DirecTV receiver needed tons of ferrite to get the RF out of it.

Tech installed a new DVR receiver with dual coax, bare bones, no ferrite.

Full power with amp and beam pointed at dish there is only a slight jiggle of 
the picture on 20 and a tiny bit of audio gets into the TV speakers on 10 

160-30 with the vertical is completely clean on the DVR and were a nighmare to 
clean up on the old receiver.

Rick, N6PE
Remember, E = M * C^2 was not the entire equation.
RFI mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [RFI] FYI - DirecTV TVI, rick darwicki <=