On Sat, Jan 2, 2010 at 12:36, K8TB <k8tb@bosscher.org> wrote:
> Peter, is the noise reduction caused by your fingers conductively
> touching the caps, or by downward pressure? If the later, use an
> insulated alignment tool and press down on different areas of the MB.
Physical pressure - caps were just handy and near the offending part
of the board (where all the ports are). Will try here in a bit with
something non-conductive to be sure.
--
Peter Laws | N5UWY | plaws plaws net | Travel by Train!
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|