[Top] [All Lists]

Re: [RFI] High Efficiency Heat Pump (or furnace) RFI ?

To: rfi@contesting.com
Subject: Re: [RFI] High Efficiency Heat Pump (or furnace) RFI ?
From: <donovanf@starpower.net>
Date: Tue, 18 Jan 2011 21:23:37 -0500 (EST)
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
During a visit to W2GPS this afternoon, we happened to discuss my 160 meter RFI 
problem.  Rick remembered that he's seen nearly identical RFI on 160 meters at 
his QTH (30 miles from here) for several years.  Like my RFI, his covers the 
frequency range from 1600 to 2000 kHz with three strong spectral peaks in the 
160 meter band.  The spectral peaks are at 57.5 kHz intervals.

I can provide a .wav file of the AM detector output of a receiver and a .jpg 
file of the 200 kHz wide signal spectrum of the RFI in the 160 meter band to 
anyone interested.



---- Original message ----
>Date: Sat, 15 Jan 2011 13:01:35 -0500 (EST)
>From: <donovanf@starpower.net>  
>Subject: High Efficiency Heat Pump (or furnace) RFI ?  
>To: rfi@contesting.com
>In the last few weeks a new strong variable frequency 100% duty cycle RFI 
>source suddenly appeared on 160 meters, radiated from a home one mile 
>southeast of my QTH 24 hours per day.  The RFI peaks in the 160 meter band on 
>variable frequencies mainly between 1801 and 1834 kHz.  Yes, this is the 
>perfect RFI storm on 160 meters! 
>Its source is a home with a recently completed major addition.  At my QTH the 
>RFI affects only 160 meters and the AM broadcast band above 1600 kHz. If you 
>place an AM receiver close to the home generating the RFI, the RFI extends 
>only from 1270 kHz to 1970 kHz. 
>The RFI has amplitude peaks and valleys at 1801, 1804, 1818, 1823, 1827 and 
>1834 kHz; however, all of those RFI peaks are not present at the same time. 
>The RFI abruptly switches among those frequencies a few times per minute, 
>apparently caused by some sort of variable speed controller.  If you listen to 
>the RFI with the receiver in the AM mode, the RFI has a continuous AM 
>modulation of approximately 1 Hertz. 
>All of the above -- especially the one mile distance from my QTH -- suggests 
>that the source may be a new high efficiency heat pump (or furnace) with a 
>variable speed motor controller.   
>While I can probably use my DX Engineering NCC-1 noise cancelling controller 
>to completely null out this RFI source in every direction except SE, I would 
>prefer to eliminate the RFI source entirely!    
>Has anyone else experienced this type of RFI?  If so, have you been successful 
>in resolving it, especially in a home other than your own?
RFI mailing list

<Prev in Thread] Current Thread [Next in Thread>