On 6/5/2014 11:52 AM, Anthony (N2KI) wrote:
Here is the info on the IOTA DLS-55. If you also get the IQ4 smart charger
module (like I did or buy the supply with the internal IQ4) it turns the
supply into an automatic battery charger/power supply. The rig can be left
attached directly to the battery at all times.
I have been using that setup for some time with a 400 watt Xantrex
XS-400 sine-wave inverter that switches from AC to inverting fast
enough to keep test gear (usually a 'scope and a counter) and a desktop
computer running without a hiccup. Two rigs can be run from the
batteries, but I need to beef up the wires.
I HAVE noticed, after the batteries (two 6V 200AH deep cycle batteries)
are discharged a while, that when the power comes back on and the DLS-55
gets to serious charging, there is very noticeable RF noise around IIRC
2.8 MHz. Will have to measure the noise. There's a SA sitting right over
it on a table; why not? Heh!
Cortland
KA5S
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|