David:
The Radar Engineers receiver is optimized for pulse noise reception. The
receiver features a small LCD "spectrum scope" that
allows the operator to see the pattern of the interference signal. With
the push of one button a snapshot of the scope screen can be saved to
memory (only one image can be stored at a time.) When searching, the saved
image can be called up to compare it to what may be seen along the search
route.
The receiver also has an RF amplifier that can be turned on and off along
with an adjustable RF Gain control that functions like an attenuator. The
signal strength indicator reads 0 to 100. The RF Gain control is used (as
I'm sure you are aware) to keep the signal strength reading about midscale
to allow changes in level to be observed easily.
The receiver comes with a 1000 Dernier nylon case with neck strap. The
operator can hang the receiver in front adjust controls with one hand while
swinging the directional antenna with the other.
The receiver battery is pretty robust and will provide several hours of
operation. Truthfully I have never used the receiver for more than one
hour.
Some of my colleagues will set their Radar Engineers receiver on the dash
of their vehicle and use it much like I use the IC-7000. I haven't done
that as I am very comfy with the 7000 and it does the job well.
73,
Frank N. Haas KB4T
Utility Interference Investigator
Florida
On Thu, Jul 30, 2015 at 2:40 PM, David Cole <dave@nk7z.net> wrote:
> Thank you!!!!!
>
> Could you expand a bit on what the Radar 242 does that the 7000 does not
> do... I have been considering adding a small portable scope to my
> FT-817ND, which I use on foot, and would like to know more about the
> Radar unit. I have seen it used, but never having used one, I lack the
> feel for it...
> --
> Thanks and 73's,
> For equipment, and software setups and reviews see:
> www.nk7z.net
>
> For MixW support see;
> http://groups.yahoo.com/neo/groups/mixw/info
> For Dopplergram information see:
> http://groups.yahoo.com/neo/groups/dopplergram/info
> For MM-SSTV see:
> http://groups.yahoo.com/neo/groups/MM-SSTV/info
>
>
> On Thu, 2015-07-30 at 12:11 -0400, Frank N. Haas KB4T wrote:
> > Over the years I've been contributing to the RFI email list, I have
> > mentioned nearly every tool I use to locate interference sources. I do
> have
> > a distinct advantage over the average ham because my employer, a large
> > electric utility in Florida, does equip me with the very best tools
> > available and has generously allowed me to buy and use additional
> devices,
>
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
--
Frank N. Haas KB4T
Utility Interference Investigator
Florida
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|