Dave:
Not a bad idea. However, I would suggest skipping the "middle man" and
going straight to the ARRL Spectrum Defense Fund lawyers. Better still,
an online petition sent to every ham via QRZ with the backing of the ARRL.
Most hams use QRZ these days so there's certainly a large audience. I'm
sure the folks at QRZ would sponsor such a petition as well. A popup
that shows up when you login to QRZ describing the issue with a link to
the petition would work well.
Anyone know who the top-guy is at QRZ?
Tony -K2MO
On 6/28/2018 2:11 PM, David Eckhardt wrote:
*_Just a suggestion:_* If every one of us sent this issue to our ARRL
section managers, Maybe, just MAYBE, ARRL would take notice and tickle
FCC. We need to cover the entire country with notifications to our
section managers. How about an effort launched from this forum?
Dave - WØLEV
On Thu, Jun 28, 2018 at 5:57 PM, Randy Standke <r55stan@gmail.com
<mailto:r55stan@gmail.com>> wrote:
I have a neighbor (3 houses away) with a SolarEdge system and on
the first
round of implementing the SolarEdge fix there was little
improvement. They
came back several more times and each time there was only a marginal
improvement. Finally, the SolarEdge folks came and discovered
that there
were areas where they did not twist the wires and did not install the
ferrites. So, it is quite possible in your case that the rework
was not
done correctly, or completely. It only takes one unfiltered
optimizer to
make a lot of RFI.
Anyway, it is good that SolarEdge folks are flying out. I suspect
they have
seen many cases where their rework instructions were not correctly
followed.
If there is any good news in this, once the fix was properly
installed the
RFI was gone.
73,
Randy KQ6RS
-----Original Message-----
From: RFI <rfi-bounces@contesting.com
<mailto:rfi-bounces@contesting.com>> On Behalf Of Tony
Sent: Thursday, June 28, 2018 1:43 AM
To: rfi@contesting.com <mailto:rfi@contesting.com>
Subject: [RFI] Solar Panel RFI Case In Kings Park, N.Y. : Update #3
All:
Some of you may recall that I've been dealing with RFI generated by a
neighbors solar panel installation since the day it was installed
in August
of 2016. I promptly notified Solar Edge, the manufacturer, about
the noise
and they acknowledged (eventually) that their components were the
cause of
the RFI.
Solar Edge: https://www.solaredge.com/us/home
<https://www.solaredge.com/us/home>
Update:
Last week, on June 21st, Solar Edge sent a contractor (Solar City) to
install RFI suppression to eliminate the RFI. The engineers from
Solar Edge
told me that they guaranteed it would work and that they've
installed this
type of RFI suppression many times before.
Unfortunately, it had little to no effect. They used small
clamp-on ferrite
cores at the optimizers (noise generators) with one turn of cable
around
each core. The reason they gave for not using a large ferrite with
multiple
turns was that multiple turns could damage the cables -- go figure.
They apologized for not solving the problem and are now flying their
engineers in from the west coast to New York to inspect the work
done by the
installer. Once again, they assured me that problem will be solved.
In my case, my neighbors installation is 150 feet from my antennas
yet the
RFI is strong at that distance. It's heard on 30 through 10 meters
so HF is
essentially unusable during the day while the system is active.
My advise to my fellow hams is this: take a good look around your
neighborhood and notice the number of solar panel systems popping up
everywhere. Imagine trying to figure out which system among them
is causing
RFI and the task of knocking on doors to find out who manufactured the
system or who the responsible party is.
Solar panel systems are not going away so the potential for RFI
issues are
likely to become widespread. In fact, California plans on making solar
panels mandatory on new homes beginning in 2020.
I think most would agree that it's time for the ARRL and other
advocates to
make a serious effort to let the FCC know how serious a problem
this is.
Signed petitions by the 160,000 members of the ARRL sent to local
congressmen might be a good place to start.
Or, we can sit on our asses and say goodbye to HF.
Tony -K2MO
_______________________________________________
RFI mailing list
RFI@contesting.com <mailto:RFI@contesting.com>
http://lists.contesting.com/mailman/listinfo/rfi
<http://lists.contesting.com/mailman/listinfo/rfi>
_______________________________________________
RFI mailing list
RFI@contesting.com <mailto:RFI@contesting.com>
http://lists.contesting.com/mailman/listinfo/rfi
<http://lists.contesting.com/mailman/listinfo/rfi>
--
*Dave - WØLEV
*
*/Just Let Darwin Work/*
*/Just Think/*
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|