RFI
[Top] [All Lists]

Re: [RFI] Spectrum Cable Boxes

To: Jamie WW3S <ww3s@zoominternet.net>, "rfi@contesting.com" <rfi@contesting.com>
Subject: Re: [RFI] Spectrum Cable Boxes
From: "Anthony (N2KI)" <n2ki.ham@gmail.com>
Date: Sun, 10 Nov 2019 21:43:27 -0500
List-post: <mailto:rfi@contesting.com>
Just tested with a commercial 13.8v 8a supply.  No RFI issue even at 1200
watts output CW.

I will monitor going forward.

Thanks!

Regards,

Anthony (N2KI)









On Sun, Nov 10, 2019 at 9:27 PM Jamie WW3S <ww3s@zoominternet.net> wrote:

> get a small Astron linear supply, preferably old stock, if newer, make
> sure the green wire inside is connected to the chassis by scraping the
> paint of so it make contact to bare metal, and while you are at it,
> remove the paint from the cabinet interior where each screw goes in
>
> ------ Original Message ------
> From: "Anthony (N2KI)" <n2ki.ham@gmail.com>
> To: "James Gordon Beattie Jr" <w2ttt@att.net>; "rfi@contesting.com"
> <rfi@contesting.com>
> Sent: 11/10/2019 9:22:54 PM
> Subject: Re: [RFI] Spectrum Cable Boxes
>
> >Update to the Spectrum Cable box testing,
> >
> >What I have tried.
> >
> >    - RF Chokes (Material 31) on power, HDMI & RG6 - DID NOT FIX RFI
> >    - Tightly wrapping the entire box in foil. - DID NOT FIX RFI
> >    - Putting the box on a 12v battery - VIOLA - NO RFI
> >
> >So now that we know its the power supply,  I have to find a 12v 3A wall
> >wart that is not affected by RFI.  Suggestions?
> >
> >Thanks!
> >
> >Regards,
> >
> >Anthony (N2KI)
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >On Sun, Oct 27, 2019 at 12:52 AM James Gordon Beattie Jr <w2ttt@att.net>
> >wrote:
> >
> >>  Anthony,
> >>  Will the cable box run on a 12VDC battery?
> >>  73,
> >>  Gordon Beattie, W2TTT
> >>  201.314.6964
> >>
> >>  Get Outlook for Android <https://aka.ms/ghei36>
> >>
> >>
> >>
> >>
> >>  On Sat, Oct 26, 2019 at 6:14 PM -0400, "Anthony (N2KI)" <
> >>n2ki.ham@gmail.com> wrote:
> >>
> >>  I have choked of all cables on in multiple locations and the box still
> >>>  "explodes".  I have no access to a 3A 12vDC power supply to try and
> swap to
> >>>  see if that makes a difference.
> >>>
> >>>
> >>>  Regards,
> >>>
> >>>  Anthony (N2KI)
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>  On Thu, Oct 17, 2019 at 9:35 PM Jim Miller  wrote:
> >>>
> >>>  > I got called out on a DFing trip because all of a sudden several
> people in
> >>>  > a
> >>>  > section of a subdivision couldn't get their garage doors to open
> one Sunday
> >>>  > morning.  By the time I got there the count was up to 5 doors as I
> >>>  > remember.
> >>>  > Long story but found a new box on the side of a garage.  It had
> been worked
> >>>  > on (or installed?) the day before. The cable company came back out
> and
> >>>  > fixed
> >>>  > it.   Most likely as it was assumed to be a bad cable connector
> >>>  > installation.
> >>>  > "Replacing" the box won't help if the coax connector isn't installed
> >>>  > properly.
> >>>  > 73, Jim KG0KP
> >>>  >
> >>>  >
> >>>  > -----Original Message-----
> >>>  > From: RFI [mailto:rfi-bounces@contesting.com] On Behalf Of Anthony
> (N2KI)
> >>>  > Sent: Thursday, October 10, 2019 6:55 PM
> >>>  > To: rfi@contesting.com
> >>>  > Subject: [RFI] Spectrum Cable Boxes
> >>>  >
> >>>  > Hello folks,
> >>>  >
> >>>  > Anyone on here have experience RF shielding a Spectrum Cable box?
> I have
> >>>  > tried all sorts of RF chokes (Material 31 1-300mHz) on the power,
> HDMI and
> >>>  > coax inputs with very little success.  Pretty much any band wipes
> out the
> >>>  > cable boxes.  Its not a proximity effect to the antenna as the 80
> meter
> >>>  > antenna is at 80 feet and about 50 feet away from the house.  Also,
> I must
> >>>  > point out that the previous cable boxes did not have these issues.
> So I am
> >>>  > fairly confident this is an RF shielding/filtering issue with the
> boxes.
> >>>  > In speaking with Spectrum, I could not reach anyone in a technical
> >>>  > department that has RFI experience. Next step and test is wrapping
> the
> >>>  > boxes with aluminum foil, or cutting the cord.
> >>>  >
> >>>  > Thanks for any suggestions.
> >>>  >
> >>>  > Regards,
> >>>  >
> >>>  > Anthony (N2KI)
> >>>  > _______________________________________________
> >>>  > RFI mailing list
> >>>  > RFI@contesting.com
> >>>  > http://lists.contesting.com/mailman/listinfo/rfi
> >>>  >
> >>>  >
> >>>  >
> >>>  _______________________________________________
> >>>  RFI mailing listRFI@contesting.comhttp://
> lists.contesting.com/mailman/listinfo/rfi
> >>>
> >>>
> >_______________________________________________
> >RFI mailing list
> >RFI@contesting.com
> >http://lists.contesting.com/mailman/listinfo/rfi
>
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>