RFI
[Top] [All Lists]

Re: [RFI] Looking for explanation...

To: rfi@contesting.com
Subject: Re: [RFI] Looking for explanation...
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Fri, 26 Jun 2020 21:24:12 -0700
List-post: <mailto:rfi@contesting.com>
On 6/26/2020 10:30 AM, Gary Peterson wrote:
Next, he plugged the treadmill, via an extension cord, into a different outlet, 
without the EMI filter.  No interference whatsoever was heard or seen on the 
waterfall.

Several possibilities. Question: Did the extension cord carry the Green wire? Could one outlet have its wiring in steel conduit but not the other?

AC line filters provide maximum benefit when they are located right at the noise source AND have their case bonded to the case of the noise source. And even then they don't always work because the Green wire may not be bonded within the equipment.

I ALWAYS recommend winding a common mode choke carrying all three conductors -- phase, neutral, and ground -- through one or more Fair-Rite #31 toroids. Use the winding guidelines in my latest (2018) transmitting choke cookbook as a starting point. Or build a choke like this one that W6GJB built to my design for our county expeditions. It's in the new ARRL Handbook, and on page 23 of http://k9yc.com/RFI-Ham.pdf Note that it should NOT be in a metallic enclosure, because that would detune the chokes, AND because connectors bonded to the enclosure would short out the choke on the Green wire, which is usually what is carrying the current that radiates.

What the choke does is prevent AC wiring from acting as a TX antenna for the noise.

73, Jim K9YC


_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>