Thanks, guys - I went out with my HF DF rig, and the one thing I'm
pretty sure of is that the point source is not nearby. Anywhere along
the neighborhood-level feed that runs along the West side of my property
I get a similarly high level, with no discernable local peak at a
particular pole, so my suspicion is that the source is further down the
line in someplace where I don't have access. I have sent a recording
and a request for help to my local power company guy, who tries very
hard and has good gear but relatively little knowledge. The line is
probably 60 years old, dating to this subdivision's beginnings, and has
required a lot of hardware replacement recently.
73, Pete N4ZR
Check out the new Reverse Beacon Network
web server at <http://beta.reversebeacon.net>.
For spots, please use your favorite
"retail" DX cluster.
On 8/10/2021 10:13 AM, EDWARDS, EDDIE J wrote:
Pete,
Ed Hare's description of the metal cross-arm on a pole structure is exactly
what our RFI investigator and line troubleshooter found on a pole on the
Salvation Army campus in Omaha. The RFI tech could not believe it was getting
stronger on higher and higher frequencies so he initially thought it was coming
from off-campus somewhere else, but we found it was coming from and very strong
on every point on the pole that had the metal arm when using ultrasound.
When one of our very experience line tech Troubleshooters came out to assist,
he looked at the pole with a metal arm and went to his truck and pulled out a
notebook. He showed us a manufacturer notification on the metal arms warning
about possible sparking/arcing on the metal arms. He had found one like that
before that had arced for so long it charred up the pole so bad the entire pole
had to be replaced. Apparently there was not a nearby ham to pick up on that
one before it cooked the pole.
The one we found wasn't charred much so the troubleshooter had a line tech
replace the arm with a non-metal cross arm. Problem solved. Salvation Army
ham station was happy.
Start searching for the source keeping in mind if might be some sort of large
metal component on a power pole. But focus on location first of course.
73, de ed -K0iL
Omaha, NE
-----Original Message-----
From: RFI On Behalf Of Hare, Ed, W1RFI
I have heard reports of noise that is stronger on higher frequencies, though.
This seems to occur when the radiating conductors are smaller than long power
lines. If there were induced currents in the metal crossarms of a structure,
for example, and a gap where sparking could take place, the resultant noise
would broadly peak on the resontant frequency of those crossarms.
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|