Appreciate that Dave. The shed is in a state of deterioration and do not
think its used for anything. Shingles are rotten on it. Thats the reason
I thought I would just ask them if i could unscrew the bulb.
Chuck
W4NBO
On 1/23/22 17:17, David Hachadorian wrote:
I had a neighbor with a sodium vapor yard light. The light would glow
dimly and then wink out. After I told him the light was cycling all
night, he replaced the bulb and all was well. Sodium vapor light is
orange, mercury vapor is light purple. They can both be problematic
with RFI when they fail, especially on 80.
Dave Hachadorian, K6LL
Yuma, AZ
On 1/23/2022 3:53 PM, Charles Plunk wrote:
I have been pondering on whether to do this or just wait until it
died on its own. I triangulated some RFI to a light over my next door
neighbors shed about 100' from my antennas. Thinks its high pressure
type. Sodium Vapor, Mercury Vapor or the like, probably 220v. It use
to be very bright. A electrician use to own the house and built the
shed including installing the light many years ago. Ramps up for a
few seconds, then suddenly dies off for more seconds, then starts
again dusk til dawn. Its not lit, so thinking the ballast or
electronics is trying to start the bad lamp I am guessing. Worse on
80m by far. Can control fairly well with NB on some rigs.
Any advice on asking the neighbors if I can unscrew the bulb? Think
that will stop it? Rather do that than suggest breakers shut off or
wiring disconnected.
Thanks!
Chuck
W4NBO
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|