I am reminded of two situations. When I was corporate engineer for a company
that owned almost 50 stations, I received a call from one of our market
engineers. He had two diplexed AM stations and an excessive third-order mix
was being radiated. I told him to pick a time when he could shut both stations
down and tighten everything up in the diplexer and antenna matching system. He
did and the problem was gone. Temperature cycling and vibration from wind can
loosen up hardware between inductors, capacitors, RF contactors, etc.
A contract engineering friend was trying to determine why an AM station had
excessive harmonics being radiated. He was poking and tapping components at
the tower and antenna tuning unit, while monitoring the level of one of the
harmonics on a Potomac field intensity meter. The poking and tapping was done
with an old, dry broom handle. When he was rapping on the “lightning loop”
between the ATU and the tower, the weld broke loose and started arcing. A
lightning loop is a large, one turn loop in the copper tubing between the ATU
and the tower. It represents a blob of inductance which, supposedly,
encourages more of the lightning to choose the spark gap across the base
insulator, rather than the ATU on its path to ground. Apparently, over time,
the lightning loop’s brazed connection to the tower work hardened, due to
jiggling slightly in the wind. The weld separated, microscopically, under the
red tower paint. The only thing that was holding the copper tubing to the
tower was several layers of hardened tower paint. Once the lightning loop was
cleaned and re-brazed, the harmonics were down to normal levels.
Both of these are good examples of entropy. Unless work is done on a system,
it will proceed toward a state of maximum randomness. Perform regular
maintenance on it or it will eventually fall apart.
Gary
K-zero-CX
And you should not discount the probability that the 'mix' is caused by
a corroded joint between two conductors somewhere.? The rusty joint
could be any where, in the near field of the TX or near the RX. Anywhere
there is enough RF to excite the joint and re-radiate.
AL, K0VM
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|