Good info on RTTY and the 940.
Tom, N4WBS
On Sun, 25 Jan 2004 22:51:57 -0500, Richard Ferch <ve3iay@rac.ca> wrote :
> On 24 Jan 2004 at 13:36:36 -0000, Tom Homsley, N4WBS said:
>
> >I have a Kenwood TS940 I am trying to set up to run FSK. Software is
> >MMTTY. Hardware is PC COM1 to RigBlaster Pro to ACC2 (13-pin DIN) on
rear
> >of 940. Reports say I have a carrier but no diddle? One report on
> >eham/elmer said the Processor-Out had to be adjusted??? Any ideas?
> >Tom, N4WBS
>
> Tom,
>
> I am not directly familiar with the TS940, but if it's like some other
> older Kenwoods, FSK keying is not done using the ACC2 connector. On my
> TS850, ACC2 does have pins for PTT, for receive audio, and for transmit
> audio you can use for AFSK, but there is no pin in ACC2 for FSK keying.
> There is a separate RCA phono jack on the back panel labelled RTTY. If
your
> radio is like mine, you have to take the FSK keying signal from the
> Rigblaster Pro and connect it to this RTTY jack, otherwise in FSK mode
you
> will only get a steady carrier.
>
> 73,
> Rich VE3IAY
>
>
>
>
--
Tom Homsley
tomhomsley@knology.net
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|