I used an amp in the hig power category but would have used it if I were low
power. I had the K3 putting out about 20 watts and the amp doing the rest of
the 700-800 watts. The amp helps keep me warm while I operate.
73, Susan K5DU
On Mon, Feb 15, 2010 at 5:57 PM, Steve and Judy <hodgson@cytanet.com.cy>wrote:
> Yep LP.
>
> I find that when using the amps I can easily adjust my output to the
> required 100 Watts and my transmitters are not flat out.
> 20 to 25 watts txer output is usually good enough for 100 watts amp
> output.
>
> Read and learn.
>
> 73 Steve ZC4Li.
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|