RTTY
[Top] [All Lists]

Re: [RTTY] Software for HAL PC-3000

To: "Anthony W. DePrato" <wa4jqs@mikrotec.com>
Subject: Re: [RTTY] Software for HAL PC-3000
From: WS7I <ws7ik7tj@gmail.com>
Date: Fri, 27 Aug 2010 12:11:36 -0700
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
ZJU.

Tony-

Writelog supports both.  ST-6000 is under Dumb terminal.  PCI-3000 is
on the menu.



On Fri, Aug 27, 2010 at 9:20 AM, Anthony W. DePrato <wa4jqs@mikrotec.com> wrote:
>
>>Guy's after a few years using AFSK  I am going back to FSK . i have
>>two Hal PC-3000 boards and a ST-6000 that i am going to hook back up
>>to a couple of my TS 850sat's I  have lots of dos software to run
>>them so i can either dust off a couple of my 486dx computers and use
>>them . But just wondered if there was any contesting software out
>>there that supports these ISA cards i can run on the  xp pro
>>machines ? I have DXLAB and N1MM on my other stations and am going
>>to hook up my DSP-4100 Unit to one of them which is supported. i
>>seem to recall that rttywrite supports the Hal and maybe RCLrtty any
>>others ? hope to have the mono banders up on one of the towers
>>before winter for rtty use. thanks for any help
>
> 73 Tony
>
>
>
> QBE  ZUT  DE WA4JQS
>
> ANTHONY W. (Tony) DePrato WA4JQS EXTRA - HEAVY
> Since 1962
> CQ DX HALL OF FAME # 35
> DXCC HONOR ROLL - 346
> A1-OP      FISTS  # 10573   SKCC #1227  F.O.P. LODGE 68
> DXCC PHONE- DXCC CW- DXCC RTTY- DXCC MIXED-5BDXCC
> DXCC  80, 40, 20, 15, 10 METERS
> WAC SSB, WAC CW, WAC RTTY, WAC SAT, 6 BAND WAC
> WAS AM, WAS PHONE, WAS CW, WAS RTTY, WAS 80-10,WAS 160 ,WAS 6 METERS
> South Sandwich Island Dxpedition Group
> CALLS HELD:
> WA4JQS/ZS1, WA4JQS/KC4, WA4JQS/4K1
> ZD8JQS, V31SS, VP8BZL, VP8SSI, 3Y0PI
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>



-- 
Jay WS7I
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>