RTTY
[Top] [All Lists]

[RTTY] Fwd: AN/UGC-129 Restoration

To: "greenkeys@mailman.qth.net" <greenkeys@mailman.qth.net>, rtty@contesting.com
Subject: [RTTY] Fwd: AN/UGC-129 Restoration
From: N4BE_Jim <N4BE_Jim@Yahoo.com>
Date: Fri, 27 Dec 2013 20:31:09 -0500
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Thanks to all who replied and offered suggestions.  MIL connectors aren't cheap 
to say the least.  Hate to pay more for the connectors than for the machine!  
But I will try the suggestions.

73 Jim N4BE

Sent from my iPad

Begin forwarded message:

> From: N4BE_Jim <N4BE_Jim@Yahoo.com>
> Date: December 26, 2013 at 10:57:11 PM EST
> To: "greenkeys@mailman.qth.net" <greenkeys@mailman.qth.net>
> Subject: AN/UGC-129 Restoration
> 
> I am restoring one of these, actually it is the newer V1 version with the 
> green lcd display.  
> http://www.decadecounter.com/vta/articleview.php?item=1139. Got it for 80 
> bucks on epay. 
> I have it working after cleaning up a frozen print head movement motor and 
> dot matrix print head pins.  It prints quite nicely now.  
> 
> I am temporarily connecting power and data with pins inserted into the rear 
> connectors, as I do not have the mating MIL connectors.  Does anyone have any 
> leads on these?
> 
> Power Connector MS27484T12F98S  with Clamp MS27506F12-2
> Data Connector    MS27484T14F35PB, With same clamp.
> 
> I have tried William Perry but have received no answer.  
> 
> Thanks,
> Jim N4BE
> 
> 
> Sent from my iPad
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>
  • [RTTY] Fwd: AN/UGC-129 Restoration, N4BE_Jim <=