Information on running 75 baud with MMTTY, 2Tone and WriteLog here:
http://rttycontesting.com/75baudrtty/75baudrtty.html
73, Don AA5AU
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Bill Turner
Sent: Saturday, April 26, 2014 9:22 PM
To: RTTY group
Subject: [RTTY] Changing MMTTY to 75 baud for the BARTG 75 Sprint
The BARTG 75 baud Sprint contest is tomorrow.
There are the four steps to change MMTTY to 75 baud:
I use FSK only, but I assume this applies to AFSK as well. If not, please let
me know.
1. Start MMTTY and go to Options>Setup MMTTY and select the Demodulator tab.
2. At the bottom, UN-check the box that says "Fixes 45.45 baud".
3 Go to the Decode tab and change the baud rate to 75.
4. Click OK. Do not skip this step or changes will not be saved.
This is a short contest - just four hours but lots of fun. Rules at:
http://bartg.rsgbcc.org/cgi-bin/hfreadcal.pl
See you there!
73, Bill W6WRT
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|