[RTTY] N1MM+ MMTTY -> decode OK, transmit diddles, no chars?

[Peter Laws <plaws0@gmail.com>]

Just updated to the latest N1MM+.  Using MMTTY as TU via DigiKeyer II.

When I send a macro, the chars burst into the interface window, I get a few
diddles, then nothing.  The radio is clearly getting PTT, but none of the
data.  Not sure where to look.  Followed the uHam setup guide for N1MM (not
+) as best I could but am missing something.  Decode is 100%.

Ideas?

-- 
Peter Laws | N5UWY | plaws plaws net | Travel by Train!
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty