Probably it was a corrupted .ini file. If this happens again just go to the
MMTTY folder and delete everything that is a .ini. Then set up again.
Remember not to put RTTY software into Program Files folder of any sort.
This software needs to be able to write to the folder that its .exe program
is in. Program Files of any sort do not allow this.
73 David G3YYD
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Thom
Sent: 05 December 2016 23:57
To: rtty@contesting.com
Subject: [RTTY] Got my tone problem fixed.
Howdy All,
I reported yesterday and my RTTY system was transmitting only the Mark Tone.
Turns out it was a problem with MMTTY. I un-installed it in my Windows 10
Laptop...deleted the folder it was installed in and downloaded a new copy of
MMTTY and 2 Tone. Re-installed both into a new folder that is not the
default folder.
I just got finished configuring MMTTY and all appears to be working properly
again...spots on my callsign on Reverse Beacon and also showing up again. I
did a few test transmissions on 40 meters. I have no idea what caused MMTTY
to malfunction.
Tomorrow, I re-tune the multiband dipole after replacing the coax and
removing the choke.
Got 6 inches of snow overnight and Winter has arrived.
Thanks
73
Thom KI8W
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|