Maybe I'm missing something in this question but, Working RTTY split is
little different then work split in any other mode.
A-VFO Rx / B-VFO Tx or vice versa.
If the object is dual Rx, one on the DX and one on the pile.
Route the audio from Rx1 to it's soundcard input channel.
And route the audio from Rx2 to the other side.
Then make the selections in the RTTY software as to which decoding
channel is which.
73, Good luck
Mike WB9B
On 2/15/2017 4:14 PM, NA6MB Mike wrote:
I have a FT-2000 which has two receivers, which is nice for working split.
I have seen some references to receiving two channels unsing N1MM+ or HRD
to do split on RTTY.
I have not had good luck working DXpeditions that are split.
Only worked if in the audio band of the RTTY program.
That is Rx 5kHz up, but not 20kHz.
Were can I find info on working RTTY (wide) split?
Mike
NA6MB
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|