If you have both hardware and software PTT enabled, this can occur.
How do you key the radio? If you are using a hardware device then disable
software PTT.
Also, you can go back into the archives of this reflector and the MMTTY
reflector (if you are subscribed) and see what others have found to correct
this issue.
Don AA5AU
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Clint Talmadge
Sent: Friday, June 16, 2017 5:06 PM
To: RTTY@contesting.com
Subject: [RTTY] MMTTY 1.70 ?
I got a new desktop and downloaded 1.70 MMTTY and set it up. After a couple
of mis-steps I got it Receiving and Transmitting - BUT - After it transmits
I have about a 30 second "tail" - that is the radio stays in TRANSMIT about
30 seconds after the last character sent. I have searched everywhere to find
what might be keeping it in TX without luck. Someone please point me at
where I might look.
Clint - W5CPT -
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|