Hi Don and Group
Trying to set up for BARTG.
The TS590 is not communicating with the Wrtielog. The port setting in the
radio are correct, ie.9600, 8 1. Same in Writelog.
Com 5 selected in Wrtielog. Same as always. Tried COM 6, but same result.
I tried a different logging program that uses that com port, and it is not
communicating with the port either.
This happened once before, after messing around with N1MM. But, then it
straightened out somehow, and started communicating ok in Writelog. Dont
Checked the connections and cables. Seem ok.
Any suggestions? I am at a loss.
Thanks Jim W4LC
WriteLog mailing list
WriteLog on the web: http://www.writelog.com/