Hi Paul
I turned off the Cat Control and it was fine after that but had to manually
change the band of course,
Polltime was already set to 1000 and Linktime was 500, Then doubled LT to 280
(was 140) and PT from 250 to 500 still the same problem
Then doubled to them again LT and PT now 500 still the same
Turned the Cat control back on and it is still changing to LSB then when I
change it back to CW it then changes it to LCW ??
It is def when the rig is polled as the frequency below the call field
disapaears for a milli second that is when it does it.
When you change the mode back the frequency displayed below the call field
disapears and it then changes the mode?
The frequency below the call field has always dissapeared like that but never
had a problem like this.
I have had a problem with the frequency logged changing out of band before on
the previous version
I will get the previous version and try that
Cheers
John G4RCG
Original Message -----
From: "John Muzyka" <g4rcg@yahoo.co.uk>
> when the frequency readout under the call field went off?
> the Orion changed Mode? went from CW to LSB?
Use the STATUS command to check your values for LINKTIME
and POLLTIME - then double them with the LT and PT commands.
If that doesn't work, you can take your pick of several older
versions at www.ei5di.com/sd/vaults.
V15.12 is working OK here.
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|