On 13/12/2010 14:23, Bert Hyman wrote:
> With ESM on and in "S+P" mode, changing my rig from UCW to LSB or USB,
> either from the front panel or by selecting a memory with that mode
> stored, caused SD to switch to "RUN" mode.
Yes, that's what it is doing.
I think the issue is "What should SD do when you change mode?",
and I'm inclined to think it should disable ESM.
> [SD doesn't remember ESM or S+P/RUN modes from session to session, and
> the doc doesn't mention any INI file parameters for them; might this be
> added in the future?]
It used to do this, but I found, as often as not, that the
old parameters were inappropriate when starting a new session,
so I removed this feature.
Anyone like to comment?
SD-User mailing list