Just came in from outside and my eyes are not adjusted yet.
I hope I do this right this time.
-------- Original Message --------
Subject: [SD-User] WinKey and V17.29
Date: Fri, 21 Feb 2014 23:21:24 +0000
From: Paul O'Kane <pokane@ei5di.com>
To: sd-user@contesting.com
Cyril G2HDR reported that the WINKEY command no longer
works to toggle between WinKey and internal CW.
I apologise for not including the following information
in the release notes for V17.29.
The WINKEY command has been replaced by two separate
commands - WINKEYON and WINKEYOFF.
What used to happen was that SD disabled WinKey if it
didn't find it, and switched to internal keying. That
doesn't happen any more, unless you use the WINKEYOFF
command.
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
--
Regards, Joe, Ronnie (Rowena), Marty & Sidney Pontek
P.O. Box 280, Dangriga, Stann Creek District
(Hopkins Village) Belize
011-501-503-7346 Belize
011-501-666-3564 Belize (cellular)
or
5204 Texas Highway 49 W
Omaha, TX 75571-6474
U.S.A.
903-434-9429 (My cellular when in Texas)
903-884-5990 (Skype telephone number)
Also, K8JP, member FOC-1743, CWops-876, QCWA-LM21894, OOTC-4607, A1OP,
SKCC-3171T, NAQCC-5798, Flying Pig-2819, FISTS-7625CC951, A1C-2299,
PG1915841
Skype: v31joepalooka
Facebook: Joe Pontek
I am looking for Vibroplex Model X, Double lever and prefer basket cases to
restore.
V3FOC, I am SKCC 10691
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|