Last night after 4 years of very happy use of SD, with only a few little
problems along the way, I had a "mare" of an evening.
When I was doing a pre contest tuning up , strong burning from the ATU ,
coil tapping switch burnt out, it's been suspect a couple of times this
year. Is now unusable.
Reconfigured rig and antennae,
worked one stn and SD logged the call. Could not enter the next call. Then
I found SD had jumped to the line below the callsign entry line OVR was
grey with the middle letter flashing on and off. I could find no way to get
back to the callsign entry line. I had to use task manager to close the
programme. Then work the next stn and repeat the switch off reboot
process. Then during I was told my signal appeared to have a "RF in the
shack" problem.
I wonder if these effects are inter-related. To try to separate out the
problems is the SD problem , my usage of the software, problems on my part
or is it also an RF feedback problem.
Using version V17.52
regards
peter G8AFN
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|