Paul,
Thanks for the reply - sorry for the delay in responding. Tried again with
version 19.20
Changing the first line of the FT991.SD from FT991 to FTDX991 - no change -
one way comms.
Tried changing to FT950 selection instead of FT991 - this breaks the log
from reading the TX/RX frequency correctly. If TX/RX is on, say, 3523.0 KHz
the log thinks it is on 352.3 KHz. i.e. factor of 10 out.
73
Allan
GM4ZUK
Please edit the first line of the FT991.SD file as follows -
Change FT991 to FTDX991, and save the updated file.
If that doesn't work, try selecting FT950, instead of FT991, with the
SETUP/CONFIG/PORTS command.
Please let me know if either option works.
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|