Gang,
I've tried using the VE7CC spotting software but here are a couple
questions:
1. I have all the filters set for CW only,yet when I CONNECT to KS4Q
node, it drops a hundred spots into the buffer and it includes the
entire band, not just CW. I do have the spotters set to K,VE only and
that is working fine - only spots posted by K,VE spotters appear. When
I do a sh/filter included is this line:
DX BandMode Filter set to Pass:
160-CW,80-CW,40-CW,30-CW,20-CW,17-CW,15-CW,12-CW,10-CW,4-MTR
so I'm pretty sure the filters are set to CW only. Since 80% of the
spots are phone, that's a lot to wade thru!
2. I tried to connect to KS4Q-1 as requested by Ernie but try as I may,
I cannot get it to connect to the CC node, only get the AR node as I
recall (KS4Q). KS4Q-1 is not in the list of available nodes in VE7CC
and I can't seem to add it, even tho I tried dx.ks4q.net:7373 address.
Any ideas?
--
Jim Stafford W4QO Roswell, GA USA
|