TRLog
[Top] [All Lists]

[TRLog] CW Keying Circuit Question

Subject: [TRLog] CW Keying Circuit Question
From: W4EF@pacbell.net (Michael Tope)
Date: Sun, 6 Jun 1999 16:54:33 -0700
Jack,

Check the T-4XC manual to be sure, but I think the Drake uses grid block
keying (negative voltage). You will most likely need a PNP transistor or a 
FET to key it properly.  

Mike, W4EF........................


Here is a suggested circuit:


           ----------------------*---> +5V
           |                     | 
           >          Emmit______|
           < 10K          /
     1K    >      Base ||/
  <-^V^V^- *-----------|  PNP Transistor
   CPU_Key_Line        |\
   (low = XMIT)          \-----------> to key input T-4XC
                        Coll.


P.S.  You will have to use the INVERT software switch with the Keyer Output 
Port 
command (e.g. KEYER OUTPUT PORT = SERIAL 1 INVERT) otherwise the CW
will be inverted


-----Original Message-----
From:   Jack Trampler [SMTP:n2jt@fast.net]
Sent:   Sunday, June 06, 1999 3:56 PM
To:     TRLog Submissions
Subject:        [TRLog] CW Keying Circuit Question


My FT-1000MP just went on the blink and I have to send it back to Yaesu.  As
such I will be using my Drake C-line as my main station for a while.  Does
anyone know if the keying circuit in the manual using a 2N2222A transistor
can key the T4XC safely or do I need a different circuit?

73,
Jack - N2JT
n2jt@fast.net
n2jt@arrl.net


--
FAQ on WWW:               http://www.contesting.com/trlogfaq.html
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:         http://web.jzap.com/n6tr/trwish.html


--
FAQ on WWW:               http://www.contesting.com/trlogfaq.html
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:         http://web.jzap.com/n6tr/trwish.html


<Prev in Thread] Current Thread [Next in Thread>