Duhhh! Disregard that question.
No. Thanks for showing me the obvious Lee!
I was so busy getting setup, I didn't do the obvious. Used a new .cfg since
I had to manually set the SS entries because I used an old .cfg.
Thanks my friend.
Jon Hamlet, W4ZW
Casey Key Island, FL
"A little bit of paradise in the Gulf of Mexico"
> -----Original Message-----
> From: Lee Hiers [mailto:aa4ga@contesting.com]
> Sent: Monday, November 29, 1999 4:04 PM
> To: W4ZW@home.com
> Subject: Re: [TRLog] Beam Headings in CQWW
>
>
> On 29 Nov 99, at 15:59, W4ZW@home.com wrote:
>
> > Worked single band this time and couldn't figure out how to get the beam
> > headings display. Needed Beam headings instead of Mults needed
> panel. Can
> > it be done in CQWW and how? Read the manual but couldn't find anything.
>
> Did you set MY GRID = your grid square?
>
> 73 de Lee
>
> --
> Lee Hiers
> Cornelia, GA
>
> aa4ga@contesting.com
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|