At N5CQ M/S this past weekend, we had a distinct problem with QSX
info on 40M packet spots. We were using 6.48 with a Yaesu FT-1000MP. When
going to a packet spot on 40SSB with QSX info in the band map, VFO A
would tune to the RX frequency fine, but VFO B would end up 150 kHz
below where it should have been. (i.e., a spot '7039.9 JA8RWU QSX 7215'
would tune VFO A to 7039.9 and VFO B to 7065.0.) At least I think it was
150 kHz - I'll admit that I was too busy to diagnose it fully. We ended up
just tuning by hand on 40M.
--
----------------------------------------------------------------------------
Kenneth E. Harker "Vox Clamantis in Deserto" kharker@cs.utexas.edu
University of Texas at Austin Amateur Radio Callsign: KM5FA
Department of the Computer Sciences President, UT Amateur Radio Club
Taylor Hall TAY 2.124 Maintainer of the Linux Laptop Home Page
Austin, TX 78712-1188 USA http://www.cs.utexas.edu/users/kharker/
----------------------------------------------------------------------------
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|