I installed the PIEXX board and chip in a TS940 and began trials with
TRlog yesterday. Found communications from Kenwood to PC working
properly in all respects.
However, PC to radio commands from TRlog seem to be over-written by
radio settings within a second. Only Alt M command works, changing mode
from CW to SSB.
Alt V and Alt B nitiate band changes, but are interrupted - sometimes
there is a changefrom USB to LSB or visa versa noted on the radio with
these commands.
Typing in frequency on the computer does not change radio setting; shift
command does not activate RIT, etc.
Again, I only have good radio to pc communications. Please advise to
w6nv@pacbell.net.
Oliver Sweningsen, W6NV
|