In a message dated 7/4/02 10:55:50 PM Eastern Daylight Time,
fdavis@nf.sympatico.ca writes:
> On my Toshiba 4080 notebook I have three serial ports. COM1 on back panel
> of
> computer; COM2 internal connection to intergrated modem; COM3 via a
> Socket PC
> Card in a side slot. When I interface my MP to COM1 and bring up TR with
> the MP
> turned on I have to cycle the radio OFF/ON for the software to work. i.e
> to
> read freq and to send CW etc...the software comes up on the display but
> doesn't
> work. When I interface to COM3 and bring up TR with the MP on the
> software
> works right away and reads the freq WITHOUT having to cycle the MP OFF/ON.
>
> Both ports have the same settings: 9600/8/none/2.
> Anyone have any clues as to whats going on??
>
> Frank VO1HP
>
Frank - I wonder if setting the ports to 4800/8/none/2 might help, since the
FT-1000MP CAT system baud rate is 4800. Maybe the two ports act differently
when internal software tries to change their baud rate setting. Just a wild
guess. 73, Bob - W3YY
--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
---
|