I have the same problem here. Worse, after you try entering the HQ
abbreviation, TR will no longer take ANY exchange greater than one character!
For
example, after attempting to log the HQ, if the next contact is in zone 28 you
will
only get to log 8. Not good. I went back to 6.62 I think. But the bad news is
that this was (so far!) the least of my problems.....
73
In a message dated 7/12/2003 2:40:10 AM Eastern Standard Time,
ve6jy@freenet.edmonton.ab.ca writes:
> Well, here using 6,73 and IN EX to Zone, your example (and another) log
> normally.
>
> 73 Don
> VE6JY
> ----- Original Message -----
> From: "K4RO Kirk Pickering" <k4ro@k4ro.net>
> To: <trlog@contesting.com>
> Sent: Saturday, July 12, 2003 06:00
> Subject: [Trlog] IARU Initial Exchange problem?
>
>
> >I'm trying 6.73 with INITIAL EXCHANGE set to ZONE.
> >It will not allow me to enter an HQ abbreviation.
> >It will only accept one alpha character as the
> >exchange. The exchange windows cycles through
> >each character typed, showing only one character
> >at a time. Hitting enter logs only the last character
> >typed as the exchange.
> >
> >For example, when I enter DA0HQ as the call, and
> >DARC as the exchange, it logs "C" as the exchange.
> >
> >Setting INITIAL EXCHANGE = NONE seems to cure the
> >problem. Unfortunately, it also stops auto-populating
> >the zone field for all QSOs.
> >
> >I can't reproduce the problem with 6.72. I can only
> >make it happen with 6.73.
> >
> >-Kirk K4RO
>
|