Mark,
Here is the release notes about the DVKDELAY and STEREOTOGGLE that works
with the SCK II. The DVKDELAY has been included since version 6.52. Ron,
KK1L ironed out a few problems in 6.71. All that is needed now is the CQ
ALT F3 call feature then it basically emulates what happens on CW.
73,
Bernie
Version 6.71 - released 30 October 2002
- Added two more DVK pins to the parallel port, pins 7 and 8. They are
activated by messages DVK5 and DVK6 respectively.
- Fixed DVKDelay and some other SO2R DVK related issues.
- Added support for new WX0B SO2R and ZS4TX Super Combo Keyer II
Stereo/Mono input. The state of either pin 5 or pin 9 of a parallel
port may be toggled using STEREO PIN HIGH = TRUE or FALSE (default)
in LOGCFG.DAT or the CTRL-J menu as well as the function key command
TOGGLESTEREOPIN. Use STEREO CONTROL PORT = 1/2/3 and STEREO CONTROL
PIN = 5/9 in LOGCFG.DAT to set the parallel port and pin to use. If
you use pin 5 then you cannot use the same port for DVK control. If
you use pin 9 then you cannot use the same port for band output. You
can probably think of other uses for this function!
Version 6.52 - Released on 3 August 2000.
- Added ability to program delay into DVK messages. Use Control-C
followed by DVKDELAY=xxxx and then Control-D in the message.
xxxx is the number of milliseconds to delay. You can program
a Control-C when using the Alt-D message editor by pressing
Control-P first and then Control-C.
****************************************************
> > You might be able to do this with a DVK provided it
> > had a way to tell TR-Log it was finished and also
> > TR-Log know how to read this signal from the DVK.
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|