Bob:
Go to the Elecraft site and download the "KIO2
Programmer's Manual". It has all the codes for the
K2.
Looks like an FR0 (that's a zero) will set VFO A
receive, FR1 sets VFO B receive. This command also
sets the split mode on/off automatically. That should
be all you need.
Otherwise you can always use the SW commands and get
any combination of button presses you need.
Ken
--- Bob Tellefsen <n6wg@comcast.net> wrote:
> I'm working on programming a couple of buttons to
> allow
> keyboard switching from vfo A to B and back again.
> George Fremin pointed me to section 5.3 in the
> manual, which
> shows how, sort of, but I need to know what codes a
> Kenwood
> would want to see to do this. I'm actually using a
> K2, but it is
> supposed to accept the Kenwood codes.
>
> Can anyone help with this?
> Thanks and 73
> Bob N6WG
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|