Hi all,
I have recently bought a G4ZLP CI-V interface that I received today. I have
tryed with my 756PRO2 with same baud rate in PC and radio and address
converted to decimal (64h = 100), thank´s to you guys. But.....it doesn´t
works...! I have noted that the voltage at 3.5mm mono jack is at 0.656V, and
negative (shield) is at center connector and positive at other side. I
normally do possitive at center and shield at the side, but maybe this is
the way here. I builded an interface some weeks ago without success, also
the voltage showed in the jack was less that 1V. I am using an old PC here,
but it is supposed to work, I use it for contests and some logging, but yes,
I haven´t use the SERIAL port, but this PC has worked with CAT at EA6IB last
year and worked.....Any suggestions, measurements, tips, etc...are
welcome..! I´ll keep on trying, do not give up..!
Josep
EA6BF
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|